Add or Remove Revit Content

After installation, you can add or remove Revit content using the Add or Remove Features utility.

To add content, you must be connected to the Internet so the installer can download the desired content from the Autodesk site.

For more information about Revit content, see Select Content for a Revit Installation.

1. On the Windows Control Panel, do the following:
   1. Select ProgramsPrograms and FeaturesUninstall or change a program.
   2. Select Autodesk Revit Content Libraries for the relevant release.
   3. Click Uninstall/Change.
2. On the installation page, click Add or Remove Features.
3. On the Add or Remove content page, select the content to add, or deselect the content you wish to remove.
4. Click Next to update your Revit installation.
5. If you changed the Default Content selection in Step 3, repair your Revit installation so the content paths will update in UserDataCache\Revit.ini, as follows:
   1. On the Windows Control Panel, select ProgramsPrograms and FeaturesUninstall or change a program. Select Revit for the relevant release. Click Repair or Install.
   2. Verify that the Repair option is enabled, and then click Repair to update your Revit installation.

The following paths may update in UserDataCache\Revit.ini:

• FamilyTemplatePath
• DataLibraryLocations
• DefaultTemplate

The next time Revit starts, it copies the new paths from UserDataCache\Revit.ini to the user profile version of Revit.ini.