GEOMARKLATLONG (Command)

Places a position marker at a location defined by latitude and longitude.

Find

This command is equivalent to the Lat-long option of the GEOMARKPOSTION command.

Position markers are annotations that indicate and label locations. A position marker typically consists of a point, a leader line, and multiline text.

This command is available only if the drawing file contains geographic location information.

The following prompts are displayed.

Latitude
Specifies the latitude of the location. You can specify the latitude in decimal degrees or degrees/minutes/seconds. The command validates the latitude so that it is between +90º and -90º.
Longitude
Specifies the longitude of the location. You can specify the latitude in decimal degrees or degrees/minutes/seconds. The command validates the longitude so that it is between +180º and -180º .