- Click
.
Find
- Specify the start point and end point of the line segment.
- Continue specifying additional line segments.
To undo the previous line segment, enter u at the prompt. Click Undo on the Quick Access toolbar to cancel the entire series of line segments:
- Press Enter or Esc to end the command, or enter c to close a series of line segments.
Draw a Line at a Specific Angle
- Click
.
Find
- Specify the start point.
- Do one of the following to specify the angle:
- Enter the left angle bracket (<) and the angle, for example <45, and move the cursor to indicate the direction.
- Move the cursor to indicate the angle.
- Do one of the following to specify the length:
- Click a point to specify the endpoint without using object snaps. Trim or extend the resulting line as needed.
- Enter the length of the line, for example 2.5.