The following message appears in the CFD Solution Monitor, and the simulation does not run:
Unable to connect to computer
This error is issued when the CFD Solution Monitor does not get a connection within four seconds from the CFD Server Manager service on the remote computer. This connection is fairly low level (tcp::connect()), so this can indicate several network issues.
Suggested Solutions include:
Ensure that the computer name is spelled correctly in the server.cfg file.
Open a command prompt, and do a "ping" to check the name and response times.
In the server.cfg file, use IP addresses instead of DNS names.
This page has been translated for your convenience using a machine translation service. This does not serve as an official translation and may contain errors and inaccurate translations. Autodesk makes no warranty, express or implied, as to accuracy, reliability or completeness of any information translated by the machine translation service and shall not be liable for any damages or loss from your reliance on the translation service.