Autodesk® Fabrication Tracker 2015 Service Pack 4 Readme

Thank you for downloading Autodesk® Fabrication Tracker 2015 Service Pack 4.

This readme contains the latest information regarding the installation and use of this update. It is strongly recommended that you read this entire document before you apply the update to your licensed copy of Autodesk® Fabrication Tracker 2015 software.

For reference, you should save this readme to your hard drive or print a copy.

Contents

·         Who Should Install This Update?

·         Supported Operating Systems

·         General Installation Information

·         Installation Instructions

·         Apply This Update to a Stand-Alone Installation

·         Uninstall This Update

Who Should Install This Update?

This update is for the following Autodesk product running on all supported operating systems. Be sure to install the correct update for your software.

Product

Update

Autodesk® Fabrication Tracker™ 2015

Autodesk_Fabrication_Tracker_2015_SP4_x64.EXE

(or Autodesk_Fabrication_Tracker_2015_SP4_x86.EXE

 for 32bit)

Return to Top

Supported Operating Systems

This update can be used with the following operating systems:

 

·         Microsoft® Windows® 7 x32

·         Microsoft® Windows® 7 x64

·         Microsoft® Windows® 8 x64

Return to Top

General Installation Information

Before You Begin

As you prepare to install this update, keep the following in mind:

Administrative Privileges

In order to apply this update, you must have administrative privileges to install and uninstall products.

Network Deployment

Special command line switches are available for administrators. The full list can be obtained by running the update with the /? Switch.

/q - Suppresses the completion message after this update is applied. This is useful if you use a script or batch file to apply this update to multiple computers.

/e - Extracts the MSP file from the update executable.

Return to Top

Installation Instructions

·         Apply This Update to a Stand-Alone Installation

·         Uninstall This Update

Apply This Update to a Stand-Alone Installation

Follow these instructions to install this update on a single computer.

1.    Download the update and save it to any folder.

2.    Close any running instances of Autodesk® Fabrication Tracker™ 2015 software.

3.    Find the folder where you saved the update and double-click the executable (EXE) file.

4.    When the installation is completed, the following message will be displayed: "The service pack was successfully installed and Autodesk Fabrication Tracker2015 has been updated."

Return to Top

Uninstall This Update

Note: This update cannot be uninstalled to revert Autodesk® Fabrication Tracker™ 2015 software to its pre-update state. If you need to remove the update, please uninstall Autodesk® Fabrication Tracker™ 2015 software and then reinstall it.

Return to Top

Cop