Autodesk®
Fabrication ESTmep™ 2015 Service Pack 1 Readme
Thank
you for downloading Autodesk® Fabrication ESTmep™ 2015
Service Pack 1.
This readme contains the latest
information regarding the installation and use of this update. It is strongly
recommended that you read this entire document before you apply the update to
your licensed copy of Autodesk® Fabrication ESTmep™
2015 software.
For reference, you should save this readme
to your hard drive or print a copy.
Contents
·
Who Should Install This Update?
·
General Installation Information
·
Apply
This Update to a Stand-Alone Installation
This
update is for the following Autodesk product running on all supported operating
systems. Be sure to install the correct update for your software.
|
Product |
Update |
|
Autodesk® Fabrication ESTmep™ 2015 |
Autodesk_Fabrication_ESTmep_2015_SP1_x64.EXE (or Autodesk_Fabrication_ESTmep_2015_SP1_x86.EXE for 32bit) |
This
update can be used with the following operating systems:
·
Microsoft®
Windows® 7 x32
·
Microsoft®
Windows® 8 x32
·
Microsoft®
Windows® 7 x64
·
Microsoft®
Windows® 8 x64
As
you prepare to install this update, keep the following in mind:
Administrative
Privileges
In order to apply this update, you must have administrative privileges to install and uninstall products.
Network
Deployment
Special command line switches are available for administrators. The full list can be obtained by running the update with the /? Switch.
/q - Suppresses the completion message after this update is applied. This is useful if you use a script or batch file to apply this update to multiple computers.
/e - Extracts the MSP file from the update executable.
·
Apply This Update to a Stand-Alone Installation
Follow
these instructions to install this update on a single computer.
1.
Download the update and save it to any
folder.
2.
Close any running instances of Autodesk® Fabrication ESTmep™ 2015 software.
3.
Find the folder where you saved the update
and double-click the executable (EXE) file.
4.
When the installation is completed, the
following message will be displayed: "The service pack was successfully
installed and Autodesk Fabrication ESTmep 2015 has
been updated."
Note: This update cannot
be uninstalled to revert Autodesk®
Fabrication ESTmep™ 2015 software to its pre-update
state. If you need to remove the update, please uninstall Autodesk® Fabrication
ESTmep™ 2015 software and then reinstall it.
Cop